Petsafe Innotek Spray Bark Control Collar - Manual (Page 12)

12 www.innotek.net
Troubleshooting
Th e Bark Control Collar does
not spray.
• Ensure that the battery is properly installed.
• Replace the battery.
• Refi ll the Lemon Spray.
• If the Bark Control Collar still does not spray, contact the Customer
Care Centre. For a listing of Customer Care Centre telephone numbers,
visit our website at www.petsafe.net.
My Bark Control Collar sprays,
but my dog keeps barking (does
not respond to the burst of
spray). • Tighten the Bark Control Collar and make sure the Sensor Probe is
centered on the front of the dog’s neck.
• Check to make sure the Spray Nozzle points towards the dog’s snout.
• Make sure your dog’s hair does not block the spray. If so, trim the hair so
the spray can reach the snout area.
• If your dog still does not respond, contact the Customer Care Centre.
For a listing of Customer Care Centre telephone numbers, visit our
website at www.petsafe.net.
When I try to refi ll the Lemon
Spray, the spray leaks out around
the Spray Nozzle. • Hold the Lemon Spray can upright. If it is held at an angle, it will not
create a good seal.
• Press fi rmly on the Lemon Spray can to create a good seal.
• If the spray continues to leak, contact the Customer Care Centre. For a
listing of Customer Care Centre telephone numbers, visit our website at
www.petsafe.net.
Compliance
Th is equipment has been tested and found to comply with relevant EU Electromagnetic
Compatibility, Low Voltage and R&TTE Directives. Before using this equipment outside the EU
countries, check with the relevant local R&TTE authority. Unauthorised changes or modifi cations to
the equipment that are not approved by Radio Systems® Corporation are in violation of EU R&TTE
regulations, could void the user’s authority to operate the equipment, and void the warranty.
Th
is product is in compliance with the provisions of the EMC and LV directives. Th e Declaration of
Conformity can be found at: http//www.petsafeinternational.com/eu/eu_docs.htm
Canada
Th
is Class B digital apparatus complies with Canadian ICES-003.
Australia
Th
is device complies with the applicable EMC requirements specifi ed by the ACMA Australian
Communications and Media Authority).
_____________________________________________________________________________
Battery Disposal
Separate collection of spent batteries is required in many regions; check the regulations in your area
before discarding spent batteries. Please see page 8 for instructions on how to remove the battery
from the product for separate disposal.
Th
is device operates on 1 battery of the type alkaline with 8 Volt capacity, replace only with
equivalent battery.