Petsafe Innotek Spray Bark Control Collar - Manual (Page 2)

2 www.innotek.net
Quick Start Guide
Step 1 Adjust the collar
Step 2 Power Up
Proper Fit: Th e collar fi t should be snug, yet loose
enough to allow one fi nger to fi t between the strap
and the dog’s neck. Fit is important because a loose
collar may cause inconsistent performance. Trim any
excess strap length.
Th e collar should be off the dog for this step.
Insert battery, positive (+) side out.
Step 3 Fill the collar
Th e collar should be off the dog for this step. Be certain the collar
is turned OFF. Hold the Lemon Spray can upright and press nozzle
fi rmly into the Refi ll Port. Hold for 15 seconds and remove.
Step 4 Using the collar
Press the On/Off button until the green LED illuminates; release the button.
Put the collar on your dog, with the spray nozzle facing toward the dog’s
snout and fasten the strap. Allow your dog to wear the collar for several
minutes then re check the fi t. You should notice a reduction in your dog’s
barking within the fi rst couple of days that he wears the collar.
Important: Th
e Bark Control Collar should not be worn for more
than 8 hours out of every 24 hour period.
15 seconds