Petsafe Elite Pendant™ Remote Trainer - Manual (Page 6)

6 Customer Care Center 1-800-732-2677
Operating Guide
Step 1
Prepare the Handheld Remote
Charge the Handheld Remote
1. Lift the rubber cover protecting the Remote’s Micro USB Port
and insert one of the Micro USB connectors ( 1A).
2. Insert the USB connector on the opposite end into the power
adapter ( 1B) and plug into a standard wall outlet.
3. Charge the Handheld Remote for 5 hours for the first charge.
Recharges take only 3-4 hours. Note: The Status Gauge will
have a solid red LED while charging and a solid green LED
when fully charged.
4. When charging is completed, replace the rubber cover.
Note: Approximate battery life between charges is 40 to 50
hours, depending on frequency of use. Ensure the Handheld
Remote is closed when no longer in use for longer battery life.
Note: Both the Handheld Remote and the Pendant
™ can also be charged by plugging into a USB port
on your computer. Charging time may be longer than when using the power adapter.
Turning On the Handheld Remote
Power up the Handheld Remote by sliding it open. You will see the status gauge display the
remaining battery life.
Handheld Remote LED - Function and Response
Handheld Remote Function Status Gauge LED Response
Good battery 3 green LEDs are solid for 3 seconds
Medium battery 2 green LEDs are solid for 3 seconds
Low battery 1 green LED is solid for 3 seconds
Critical battery Red LED flashes for 3 seconds
Any stimulation button pressed Red LED is solid for length of button press
Tone button pressed 1 green LED is solid for length of button press
Step 2
Prepare the Pendant
™
Receiver
Charge the Pendant
™
Receiver
1. Lift the rubber cover protecting the Pendant’s Micro USB Port and insert one of the Micro
USB connectors ( 2A).
2. Insert the USB connector on the opposite end into the power adapter ( 1B) and plug into a
standard wall outlet. The red light will appear. Note: The Handheld Remote and the Pendant ™
Receiver can both be plugged in to the charger at the same time.
USB Cable
placed in the
Handheld
Remote Micro
USB Port
1A
1B