Petsafe Deluxe Big Dog Remote Trainer - Manual (Page 18)

18 1-800-732-2677
To Pair the Remote Transmitter
and Receiver Collar
If your Receiver Collar does not beep when the Tone Only Button
of the Remote Transmitter is pressed, or if you feel the Receiver
Collar is not responding to the Remote Transmitter:
1. With the Receiver Collar off your pet, turn the Receiver Collar on.
2. Turn the Intensity Level Dial on the Remote Transmitter to “1”.
3. Separate the Remote Transmitter and the Receiver Collar by 2
feet.
4. Press both the top and bottom buttons on the Remote
Transmitter at the same time and hold for ten seconds.
5. The Receiver Collar should emit two beeps.
6. If the Receiver Collar does not beep twice, please contact the
Customer Care Center at 1-800-732-2677.
1
2
3 4
5
6
7
8 9
0 1
____________________________________________________________________
Test Light Instructions
A-67
1. Turn the Receiver Collar off.
2. Loosen the Contact Points with pliers.
3. Bend the leads around the base of Contact Point.
4. Hand tighten the Contact Points, making sure that the leads stay in
contact with the base of each Contact Point.
5. Turn the Receiver Collar on.
6. Press the Stimulation Only Button on the Remote Transmitter.
7. The Test Light will fl ash. Note: At higher Intensity Levels, the Test Light
will fl ash brighter.
8. Remove the Test Light and tighten the Contact Points with pliers
one-half turn beyond fi nger tight.
9. Save the test light for future testing.
Note: If the Test Light does not fl ash, install new batteries and re-test. If Test Light still does not fl ash,
contact the Customer Care Center at 1-800-732-2677.
0224B_03_400-721-11.indd 18 0224B_03_400-721-11.indd 18 26/2/05 2:18:48 am 26/2/05 2:18:48 am