beautypg.com

Important instructions – Outdoor Great Room GI-29 Insert surrounds IS-42 User Manual

Page 2

background image

2

42000 Rev C 8-26-13

IMPORTANT INSTRUCTIONS

When using electrical appliances,basic precautions should always be followed to reduce the risk of
fire,electrical shock,and injury to persons including the following:

DANGER-High temperatures may be generated under certain abnormal conditions. Do not
partially or fully cover or obstruct the front of the heater.

1. Read all instructions before using this appliance.
2. Do not use outdoors.
3. This appliance is not intended for use by children or others, unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their safety.

4. Children should be supervised to ensure that they do not play with the appliance.

5.

This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.

6. Extreme caution is necessary when any heater is used by or near children and whenever the

heater is left operating unattended.

7. Unplug power cord before servicing or moving the heater. Always unplug heater when not in

use.

8. Do not operate any heater with a damaged cord or after the heater malfunctions, has been

dropped or damaged in any manner. Return heater to authorized service facility for
examination, electrical or mechanical adjustment, or repair.

9. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations.

Never locate heater where it may fall into a bathtub or other water container.

10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like.

Arrange cord away from traffic area and where it will not be tripped over.

11. To disconnect heater, turn controls to off, then remove plug from outlet.
12. Connect to properly grounded outlets only.
13. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it

may cause an electric shock or fire or damage the heater. Do not block or tamper with the
heater in any manner while it is in operation.

14. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft

surfaces, like a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,

paint, or flammable liquids are used or stored.

16. Use this heater only as described in this manual. Any other use not recommended by the

manufacturer may cause fire, electrical shock, or injury to persons.

17. Where possible, avoid the use of extension cords because the extension cord may overheat

and cause a risk of fire.

18. This heater includes an overheat protection system that shuts off the heater when parts of the

heater are getting excessively hot. If the heater shuts off, immediately turn the heater OFF and
inspect for any objects, on or adjacent to the heater, which may cause high temperatures. DO
NOT OPERATE THE HEATER UNTIL IT IS RESET. To reset the heater, turn it OFF, unplug it
from the electrical outlet, and wait five to ten minutes for the unit to cool down before plugging it
back in and turning the heater on.

19. Make certain that the power source conforms to the electrical requirements of the heater.
20. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place

heater on soft surfaces, like a bed, where openings may become blocked.

21. A heater has hot and arcing or sparking parts inside. It must NOT be used in potentially

dangerous locations such as flammable, explosive, chemical-laden or wet atmosphere. This
heater is intended for use in general use only.

WARNING: DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF
DISCONNECTING POWER WHEN SERVICING OR MOVING THE HEATER. ALWAYS
UNPLUG THE POWER CORD.

WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK---DO NOT USE THIS
HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES.

22. SAVE THESE INSTRUCTIONS.



This manual is related to the following products: