Outdoor Great Room Tuscany II Pergola User Manual
Page 6
6
Required Materials:
(X16) 3/8” concrete anchors.
(Check with local building codes for proper anchor
length requirements)
Electric drill suitable for concrete use.
½ ” socket wrench or similar tool.
Silicone adhesive suitable for outdoor use.
1.Once appropriate positions have been located for all col-
umns and beams you will notice four (4) holes at the base
of each column positioned in the orientation shown below
2. Pre-drill all holes with a 3/8” bit suitable for concrete. Pre-
drill pavement with a 3/8” bit to a depth adequate for the
selected anchor bolt length.
3. As shown, (at right) insert concrete anchors (not supplied)
into holes and tighten sufficiently.
Note: Ensure that all columns are shimmed a minimum of 1/8”
from pavement to ensure possible water exit.
Once bolts are installed and secured tightly, apply a thin ring
of silicone adhesive to the shallow ridge around bolt hole.
Place cap in ridge and wipe away any excess silicone. Allow
adequate time to dry before exposing to rain or snow.
Your Tuscany II pergola is now securely anchored!