Outdoor Great Room Uptown Fire Pit Table User Manual
Page 8
8 |
P a g e
3. To properly install ignition system, a spark and ground wire
need to be attached to the igniter box.
Thread black spark wire which hangs from burner
through access hole alongside metal flex-line and plug
into sparker box.
Plug the included grounding wire into the back of the
sparker box. The free end of the grounding wire should
be secured to the underside of the burner by loosening
one of the nuts on the end nearest to the control panel
and inserting the plug as shown before re-tightening
the nut.
Test system by depressing the button on the igniter. A
continuous repeating spark between the igniter
electrode and spark-receiving probe means everything
is connected properly. Consult the troubleshooting
section if spark is weak, intermittent, or not present.
4.
Once ignition system is grounded and gas
connections are secured and checked for
leaks, set the burner back into its original
position if you haven’t already done so.