Nexen 5H70PSP 914000 - Manual (Page 11)

11 FORM NO. L-20060-U-1209
B. BearInG rePlaCeMenT
refer to Figures 5-7.
1. Drive Flange Bearings (Item 12)
a. Remove Retaining Ring (Item 13).
b. Push Bearings (Item 12) out of Drive Flange
Assembly (Item 17).
c. Clean Bore of Drive Flange Assembly with fresh
safety solvent.
d. Apply Loctite ® 680 to O.D. of new Bearings and
press new Bearings into Drive Flange Assembly.
nOTe: When installing new Bearings, carefully
align Bearing O.D. with Drive Flange bore
to prevent Bearing misalignment.
e. Install Retaining Ring (Item 13).
2. Cylinder Bearing (Item 11).
a. Press Drive Ring out of Cylinder Bearing (Item 11),
and Cylinder (Item 2).
b. Press Cylinder Bearing (Item 11) out of Cylinder
(Item 2).
c. Clean Bore of Cylinder with fresh safety solvent.
d. Apply Loctite ® 680 to O.D. of new Bearings and
press new Bearings into Cylinder.
nOTe: When installing new Bearings, carefully
align Bearing O.D. with the Cylinder bore
to prevent slivers of aluminum from
getting trapped under the bearing and
causing misalignment.
e. Supporting the inner race of the new Bearing, press
the Drive Ring into the new Bearing.
12
13
Drive
Flange
FIGure 5
FIGure 6
11
2
Drive Ring
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.
CAUTION
Do not press on the Drive Ring
Face Teeth, doing so will damage
the teeth.
ParTS rePlaCeMenT (continued)