MK Diamond MK-101-24 - Manual (Page 30)

30
1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.
(A)
Place the Water Pump
in an external container.
(B)
Run the saw until clear
water is seen at the blade
cooling ports
(Approx. 1 minute).
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
(C)
Remove the Water Basin.
Ensure water is not forced into the motor casing when cleaning.
(D)
Clean the Movable Cutting
Table Guide Bar.
(E)
Clean the Movable Cutting
Table Roller Wheel Frame
Support.
(F)
Clean the remainder of
the saw.
CAUTION
CAUTION
MK-101-24 CLEANUP
NOTES
CLEANUP