MK Diamond MK-101-24 - Manual (Page 21)

21
Prior to beginning work, a pre-start inspection of the saw should be performed.
1. To prevent the possibility electrical shock, the MK-101-24 MUST be de-
energized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts.
(A)
Ensure the ON/OFF Switch
is in the OFF position.
(B)
Verify the Movable Cutting
Table moves freely.
(C)
Inspect the Diamond Blade for
damage – verify the blade is
correct for the material being cut.
(D)
Inspect the Pump Assembly
for damage – ensure the cord
is free of cracks or cuts.
(E)
Inspect the MK-101-24
for damage – ensure the cord
is free of cracks or cuts.
(A)
Connect the Cooling Transfer
Tube to the inlet connection
of the Blade Guard.
(B)
Connect the Water Pump power
cord to the connection found on
the back of the motor.
WARNING
MK-101-24 SETUP
Pre-start Inspection
Connecting the Water Pump
NOTE:
To prevent pump damage, the Water Pump must be disconnected during
dry cutting operations.