MK Diamond MK-101-24 - Manual (Page 14)

14
Receptacle is for
water pump only.
125V, .6 amps max.
! CAUTION
This saw is to be used
with a Ground Fault
Circuit Interrupter.
! CAUTION
Label E
Label F Label G
Label D
Label B
Label A
Label C
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
!
For Your Own Safety Read Instruction Manual
Before Operating Saw.
Wear Eye Protection.
Disconnect Saw Before Servicing, when Changing
Cutting Wheels and Cleaning.
Use Tool Only with Smooth Edge Cutting Wheels
Free of Openings and Grooves.
Replace Damaged Cutting Wheel Before Operating.
Do Not Fill Water Bath Above Water Fill Line.
See Manual for Pump Replacement.
! WARNING
NOTICE
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’
100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length
No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
!
For manuals and parts
lists scan the QR code
with your smart phone
MK-101-24 SAFETY
SAFETY LABEL LOCATIONS
Safety labels contain important safety information. Please read the information contained on each
safety label. These labels are considered a permanent part of your saw. If a label comes off or
becomes hard to read, contact MK Diamond or your dealer for a replacement.
Decal/Label Location Description
A Motor - Side Warning - Read and Follow Operating Instructions
B Motor - Front Warning - Silica Warning
C Motor - Front Notice - Voltage/Extension Cords
D Motor - Back Service/ Warranty
E Motor - Back Caution - Use with GFCI only
F Motor - Back Caution - Receptacle for water pump
G Motor - Back QR Code for Manuals
H Water Pump Pump Specifications
A
G
C
B
H
D
F
E
Warning Label Sheet Part # 166012