B&C Technologies HP Series Commercial - Manual (Page 17)

When installing the washer-extractor, it is
important to allow adequate clearance on
all sides of the machine. When multiple
machines are installed, it is important to
allow for the specified minimum clearances
between machines. The following table
shows recommended minimum clearances
for the various freestanding models. Note
The dimensions are approximate and
subject to normal manufacturing tolerances.
If exact dimensions are required for
construction purposes, request certified
drawings from the factory. We reserve the
right to make changes at any time without
notice.
16
Installation
Dimensional Clearances
A
B
C
D
UNITS UNITS
Metric US
(A) Minimum rear clearance mm in 760 30 305 12
(B) Minimum clearance between
machine and wall
mm in 455 18 25 1
(C) Minimum clearance between
machines
mm in 455 18 25 1
(D) Minimum front clearance mm in 838 33 838 33
HP Series
Recommeded Minnimum