Allen&Heath ILIVE MIXPAD - Manual (Page 4)

There are 3 Screen Modes -
CH , MIX and Setup . Select a mode from the
buttons in the toolbar.
CH (Processing) Mode:
Use this to access channel processing
– Preamp, Trim and HPF, Gate, PEQ,
GEQ, Comp, Lim/De-ess or Delay. The channel strips are shown in the
bottom panel, the selected channel processing in the top panel.
Single tap the channel Name to select it. The yellow status box in the toolbar
displays which channel is currently selected.
Use the ‘In’ button to switch processing in or out. Curves turn yellow when
switched In. Control value boxes change colour when they are active.
PEQ
– Drag the PEQ band dots around to shape the EQ. Move up/down to
adjust Gain, sideways to adjust Frequency, and pinch vertically to adjust
Width. Buttons are available to switch the EQ in/out and to flatten the EQ.
GEQ
– An RTA fed by the current PAFL selection is displayed above the
GEQ. Touch PAFL to display the RTA for the selected Mix. Note that this will
override PAFL at the Surface too. Buttons are available to switch the EQ
in/out, to flatten the EQ, and to select one of four GEQ models.
FX Tap Tempo
– If an FX is a Delay then the top panel displays two Tap
buttons, one for each side of the stereo delay. Touch the Linked button for
mono delay. In this case the button on the left is used to tap in the delay time.
To access the mix sends and routing touch the MIX mode button in the
toolbar.
MIX (Routing) Mode:
Use this to access the Mix sends, pre/post settings and assignments. Both
panels show channel strips selectable using the tabs. For example, you could
display your Inputs in the bottom panel, and Mix masters in the top panel.
Double tap the channel Name to select its Mix view. The send strips change
colour to follow that of the selected Mix master. Work with the routing in the
top and bottom panels just like you would using the iLive Surface. The blue
status box in the top right displays which mix is currently selected.
To access the channel processing touch the CH mode button in the toolbar.
Setup Mode: