Allen Sports SST1 - Manual (Page 5)

INSTRUCTIONAL
OWNER’S MANUAL
p
5
SAFETY FLAG INSTALLATION
STEP 1: Assemble the flag and insert the end into the small sleeve on the side of the
trailer skin. Reattach the Velcro to secure the cover.
NOTE: Flag should be removed before attempting to fold trailer
WARNING!: This flag is meant for use only with the trailer. This flag is not a toy. Do not let your child play
with this flag at any time. Failure to comply with this warning could result in serious injury
of your child.
WARNING!: Your trailer is designed to attach to most full-sized bicycles. The trailer’s hitch must be
attached to the rear axle of the bike. Do not use trailer if the hitch can not be securely
attached to rear axle. It is recommended that the bicycle(s) to which the trailer will be
attached undergo a safety check by a qualified bicycle mechanic before attaching trailer.
This trailer should never be used with electric bicycles, or any motorcycle or any motorized vehicle
ATTACHING TRAILER TO BICYCLE
STEP 2:
STEP 3:
STEP 4:
STEP 1:
Position hitch over left rear axle of bicycle frame (Fig16).
Loosen LEFT side rear axle to allow the trailer’s hitch to attach to frame (Fig15).
Tighten axle nut securely, testing to see that hitch is unable to pull loose.
Loop Safety Strap around frame and secure to D-ring on hitch arm (Fig 17).
WARNING!: Safety strap must attach to the bike frame when using this product in trailer mode.
FIGURE 15. FIGURE 16. FIGURE 17.