Allen Sports AST100 - Manual (Page 3)

INSTRUCTIONAL
OWNER’S MANUAL
p
3
TRAILER ASSEMBLY & OPERATING INSTRUCTIONS
STEP 1:
STEP 2:
STEP 3:
WARNING!: IMMEDIATELY DISCARD ALL PLASTIC BAGS AND WHEEL WRAPPING MATERIALS!
WARNING!: The spring-release pins must be engaged for safe operation of the trailer. Failure to Assemble
properly may result in injury. If the spring-release pins do not engage properly, DO NOT USE.
Call the customer service number as indicated in the attached literature for assembly assistance.
Remove the trailer from the box and check contents against the parts list.
NOTE(S): 1. Lay the trailer on the ground with the black fabric side down.
2. Do not remove the white foam from the wheel axles until STEP 4
OPEN FRAME -Unfold trailer by pulling the frame and remove all components from inside.
A. Notch the small plastic “box” with red release latch on the rear of the front window frame tubes.
B. Notch the small, round-tipped slide pin on the front of the rear window frame tubes.
C. Lift both front and rear tubes at the same time, and insert the round-tipped slide pin into the slot
in the bottom of the small plastic locking “box”.
D. Lift up to pull the two parts together. When engaged, you will hear a small “click” noise. To release the
frame for folding, simply press the red button on the side of the “box”, while at the same time, pushing
down on the rear window frame tube.
RELEASE THE TOW BAR
1. Turn the trailer on its side so the hitch arm is along the top edge [Fig. 3].
2. Find the quick-release pin that holds the tow bar in place in the tow bar bracket [Fig. 3a]
3. Open the loop of the quick-release pin and remove the pin.
4. Rotate the hitch arm forward until it is seated in the U-channel [Fig. 3b]. Re-install pin in front
holes in the U-channel and close the snap pin so the loop of the pin lock is over the pin shaft.
FIGURE 3.
FIGURE 2.
FIGURE 1.
FIGURE 3A.
FIGURE 2A.
FIGURE 1A.
FIGURE 3B.
FIGURE 2B.