Failover configuration, Failover reference configuration 3 – Dell PowerVault TL2000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Dell PowerVault™ TL4000/TL2000 Failover Guide
Failover configuration
(one host, two NBAs, two switches, two FC drives)
Main Path
Failover Path
Figure 2: Reference Configuration 2
Failover Reference Configuration 3:
One host with dual port SAS HBAs and one Dell PowerVault^"* with two SAS drives
In this configuration, failover occurs if one of the following occurs:
- One of the drives fails (hardware failure or is drive disconnected from the HBA port)
- One of the HBA ports fails
- One of the ports in a drive fails
This configuration takes full advantage of path failover; it is protected via data and control path.
The physical connection of this configuration is shown in Figure 3.
Important Note: Dell Recommends Fibre Channel drives to be same generation. For Heterogonous
configurations refer to section: Heterogonous Validated Configurations
6 | P a g e
1 2 / 3 1 / 0 9 v e r s i o n 2 . 0
Always