Dell powervault^*^ tl4000/tl2000 failover guide, Single fc drive failover configuration, Lt05 specific requirements for failover support – Dell PowerVault TL2000 User Manual
Page 11: Failover reference configuration 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
a
Dell PowerVault^*^ TL4000/TL2000 Failover Guide
Single FC Drive Failover configuration
(Two HBA adapters, One FC switch, and one FC drive)
Main Path
Failover Path
Figure 7: Reference Configuration 7
LT05 Specific Requirements For Failover Support
The introduction of LT05 drive support in the Dell PowerVault™ TL2000 and TL4000 allowed additional
failover configurations. These configurations are unique to the Dell PowerVault™ TL2000 and TL4000
configured with LT05 devices and do not extend to LT04 configurations.
Important Note: Failover is only supported on Dell PowerVault™ TL2000 when configured with LT05
drives
Failover Reference Configuration 8:
One host with two Fibre Channel ports, one Fibre Channel switch, and a Dell PowerVauir*^
configured with three Fibre Channel drives
In this configuration, failover occurs if one or more of the following occurs:
- One of the drives fails (hardware failure or is drive disconnected from the HBA port)
- One of the Fibre Channel ports in the HBA fails
11 I P a g e
1 2 / 3 1 / 0 9 v e r s i o n 2 . 0