Vermont Casting VCS501 - Manual (Page 4)

4 30005436
VCS501 Series Assembly
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
B347
attach skirt assy
11/10
Step 2b: Attach Skirt
(Optional)
Parts Required:
(1) Skirt Left Assembly
(1) Skirt Right Assembly
(1) Skirt Front Assembly
() Skirt Corner Assemblies
(7) #10-4 x 1/” Screws (50000337)
(4) Adjustable Leveling Glide
Figures 2 & 3
NOTE: Remove protective coating from corner posts
before proceeding with this step.
Screw-in two () adjustable leveling glides into hex
threaded insert provided in front skirt assembly.
Screw-in one (1) adjustable leveling glide into hex
threaded insert provided in left and right skirt assem-
blies.
Attach left skirt assembly to the unit:
– Loosen one hex bolt from corner post. (Refer to Corner Post
Detail)
– Slide left skirt assembly between bottom panel and
side panel.
– Secure left skirt assembly with two () #10-
4 x 1/” screws.
– Tighten hex bolt at the back of the
unit.
Repeat these steps for right side.
NOTE: If you have any problems sliding the
skirt assembly (left or right), loosen four (4)
screws on side panel and lift the side panel to
allow more space.
Slide two () skirt corner assemblies into the
front skirt assembly. Slide above assembly
into attached left and right skirt assemblies.
Secure all skirt assembly parts with three (3)
#10-4 x 1/”
screws.
Skirt Left
Assembly
Skirt Corner Assembly
Skirt Front
Assembly
B347
#10-4 x 1/”
Screws
Figure 3
Corner Post/Skirt Detail
Loosen Outer Bolt
at Back Side
"
ATTACH
Leveling
Glide
Skirt Right Assembly
Skirt Front Assembly
Skirt Left Assembly
B157
Figure 2
Leveling
Glide
Inverted View