Conair EARTHSMART UGH031-0209 - Manual (Page 61)

Tr o u b l e s h o o t i n g l 6 - 9
C h e c k i n g o r R e s e t t i n g t h e C i r c u i t
B r e a k e r s
The EarthSmart ECM Series Chiller uses electrical circuit breaker to protect the
chiller from overloads or improper operating conditions.
To check or reset the chiller’s circuit breakers:
1 Disconnect and lockout the main power supply.
2 Remove the chiller’s top lid, by first removing both side panels and then the
four (4) retaining bolts that secure the chiller’s top lid.
3 Locate the appropriate circuit breaker(s), located behind the chiller’s
control panel. See the wiring diagrams that came with your chiller.
4 Check the circuit breaker(s) position and condition. The chiller will not
operate correctly if one or more circuit breakers have been tripped (facing
down).
5 Reset the circuit breaker(s), if necessary.
6 Replace the chiller’s side panels and then the top lid by replacing the four
(4) retaining bolts.
7 Reapply main power.
IMPORTANT: Always refer
to the wiring diagrams
that came with your
chiller to locate specific
electrical components.
Illustrations in the User
Guide are intended to be
representative only.
Circuit Breakers