Conair EARTHSMART UGH031-0209 User Manual
Page 31
C o n n e c t i n g t h e M a i n P o w e r
The Conair EarthSmart ECM Chiller uses standard 115 Volt, 60 Hz or 220 Volt,
60Hz single-phase power, depending on model.
To connect the the main power to the chiller:
1
Connect the chiller’s plug into a properly-sized and rated electrical outlet.
IMPORTANT: Always refer
to the wiring diagrams that
came with your chiller to
locate specific electrical
components. Illustrations in
the User Guide are intended
to be representative only.
CAUTION: Always disconnect and lock out the main power sources before making
electrical connections. Electrical connections should be made only by a qualified
electrical technician.
I n s t a l l a t i o n l
3 - 9
3
Installa
tion
220 Volt/60 Hz,
20 amp plug
IMPORTANT:
Depending on the state of the refrigeration system the compressor may turn on
momentarily upon connecting power. The compressor will stop when the refrigerant is
pumped into the condenser and a low pressure condition exists in the evaporator.