Powering up the first time – Motorola CG4500 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I N S T A L L A T I O N
NOTE
To turn on your CG4500, simply plug it in. It is
not necessary to unplug it when not in use.
Powering Up the First Time
You must allow 5 to 30 minutes to power up the first time because the CG4500
must find and lock on the appropriate channels for communications.
Be sure that your computer is on, the
Motorola Communications Gateway
CD-ROM is in the CD-ROM drive and has been read, and the CG4500 is
unplugged.
Plug the CG4500 power cord into your electrical outlet. Notice that the
LEDs on the front panel cycle through this sequence:
•
Power blinks during a self-test. When the self-test is successfully
completed, the light is solid green.
•
RX blinks while the CG4500 scans for the downstream channel. When
the downstream channel is locked, the LED is solid green.
•
TX blinks while the CG4500 scans for the upstream channel. When
the upstream channel is locked, the LED is solid green.
•
ONLINE blinks while the CG4500 is obtaining configuration
information. When the configuration information is obtained, the LED
is solid green.
During normal operation, the Power, RX, TX, and ONLINE LEDs are on and the
Activity LED blinks.
1 5