Xpres Subli-Print Epson D88: Bulk Feed instructions - Series 3 - Manual (Page 4)

Re-filling Bottles
Do not allow the ink to fall below
the red line on the bottles
Lay the bottles down and remove the
filter cap of the colour you wish to fill.
Use the syringe (with the small
attachment you find in the handle) to fill
this colour. Note you cannot fill it further
than the hole allows (do not stand it up
so you can fill the small chamber - this
system works with the smaller chamber
partially empty).
Clean the syringe between any further
colours you may wish to fill.
Return the bottles to the upright position
and replace any air filter caps.
Note : some of these images are taken
from the 1290 6 colour system
FULL
Page 4