Xpres Subli-Print Epson D88: Bulk Feed instructions - Series 3 - Manual (Page 3)

Remove the red tape and fit the tube supports
additional clamp. This helps ensure that the tube
support remains in position.
Remove the rubber stoppers from the bottles …
… and put the air filters in place. You can now
replace the Mains Plug and turn the printer on.
The printer will go into an ‘ink charge’ m ode and you
will see any air in the tubes start to move towards the
printhead. This air causes obsolutely no problems and
will eventually disappear into the tops of the
cartridge. The amount of air in the tube is totally
insignificant to the cartridge. You can now print off a
nozzle check to see if the printer has fully charged
and is ready to print. If there are any breaks in the
nozzle check you can perform a head clean or two
until the nozzle check is perfect. If the nozzle check is
not correct after 3-4 head cleans leave the printer to
settle for an hour then try another nozzle check, it
should now be ready to print.
Page 3