Workrite Series VALUE Assembly Instructions for Tables with Left Front Crank - Manual (Page 8)

8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sonoma Series™ VALUE Workcenters - Assembly Instructions for Tables with Left Front Crank
a
b
c
10
Attach and Connect Left Leg and Crank Handle
Attach crank handle mechanism to Crank Tube, using
Crank Handle Hex Shaft. Insert short end into leg and
long end through Crank Mechanism and into Crank
Tube.
Slide Crossbar over Leg Bracket on Left Leg and
secure using two Lock Washers and Button head
Machine Screws.
For base-only version, proceed to step 11.
Attach top plate of Left Leg to desk using 10 wood
screws provided. Use locating holes. If you use an
electric screwdriver, be sure it is on the lowest torque
setting to avoid stripping the threads.
Attach crank mechanism to desk using remaining
six wood screws, but do not tighten them at this
point.
Gently pull out the handle and test that it will clear
the table so that it can be rotated.
If you have a Workrite tabletop, proceed to
step 12.
d
S
T
N
H
R
Left Leg
V
V
V
a
b
c
d
a
b
c
Attach Right Leg (Leg 1) to Crank Tube, Crossbar and Table
Use second Side Entry Hex Shaft to connect Leg 1 to Crank Tube,
inserting short end of shaft into leg and long end into Crank Tube.
Slide Crossbar over Leg Bracket on Leg 1 and secure using two Lock
Washers and Button head Machine Screws.
9
a
b
c
M
H
G
Leg 1
S
T
V
A
For base-only version, proceed to step 10.
Attach top plate of Leg to desk using 10 Wood
Screws provided. Use the locating holes. If you use
an electric screwdriver, be sure it is on the lowest
torque setting to avoid stripping the threads.
Note that the Stiffener
Bracket shown between
the leg and the Crossbar
Bracket applies only to
2-Leg Tables.
B