Workrite Sierra Crank Assembly Instructions for Front and Top-Crank models - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Workrite Sierra™ Crank Workcenters - Assembly Instructions
L
a
b
c
Attach Crank Tubes and Crossbars to Side Legs and Table
Use Long End Hex Shaft to connect Right Leg to Crank Tube, inserting short end of shaft into leg
and long end into Crank Tube.
Use Short End Hex Shaft to connect Left Leg to Crank Tube, inserting short end of shaft into leg
and long end into Crank Tube.
Attach Crossbars to side legs using two Button head Machine Screws per leg.
Base-only models, skip to step 5.
Attach top plate of Legs to desk using 10 Wood Screws provided. Use the locating holes. For Front-
crank models, keep the two holes nearest the inside of the leg where the crank will be inserted free
for now. If you use an electric screwdriver, be sure it is on the lowest torque setting to avoid strip-
ping the threads.
Proceed to Step 5 on page 10.
a
b
d
P
M
J
J
H
P
I
I
d
Right Leg Left Leg
d
c
c
4
H