Workrite Sierra HXL Crank Assembly Instructions for 2-Leg Top Crank models - Manual (Page 4)

4 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra HXL™ 2-Leg Top Crank Workcenters - Assembly Instructions
Attach Short and Medium Brackets to Leg Assembly
Attach both Short Brackets (B) using M6 × 8 mm Button Head Screws (J). Do not tighten screws
completely - allow them to slide left and right in Bracket.
Attach Medium Brackets (C) to sides of Legs using M6 × 8 mm Button Head Screws (H). If you
have a 24" deep or less worksurface, use the holes to the rear of the Bracket as shown. For deeper
worksurfaces, use the center holes of the Bracket as shown. Do not tighten screws completely -
allow them to slide left and right in Bracket.
3
a
b
Attach Long Bracket to Left Leg
With legs on their sides, attach
Long Bracket (P) to back of Left
Leg Cap using M6 × 8 mm Button
Head Screws (J). The Bracket
should have the lip on top, facing
away from the leg. Do not tighten
screws completely - allow them to
slide left and right in Bracket.
a
Back
Back
Left Leg
Right Leg
4
B
B
J
J
C
C
J
J
C
C
J
J
H
Front
Front
P
J
H
24" deep
30" deep
24" deep
30" deep
a
b
b