beautypg.com

Safety, Installation, Pre-installation check – Wine Guardian Humidifier - Manual User Manual

Page 11

background image

10

Safety

The Wine Guardian Humidifier uses 24-volt power through a 120-volt transformer plug or
digital control through the Wine Guardian main control unit.

CAUTION

BE SURE TO DISCONNECT THE MAIN POWER TO THE COOLING UNIT OR TO THE

HUMIDIFIER. THE POWER PLUG OR COMMUNICATION CABLE SHOULD BE DISCONNECTED

AT ITS SOURCE BEFORE SERVICING.

CAUTION

THE WATER SUPPLY TO THE HUMIDIFER MAY BE HOT. TURN OFF THE HUMIDIFER AND

ALLOW THE WATER TO COOL BEFORE SERVICING THE HUMIDIFIER.

METAL AND PLASTIC EDGES CAN BE SHARP AND CAUSE INJURY IF NOT HANDLED

PROPERLY. FAN BLADES CAN ALSO BE SHARP. DO NOT PUT FINGERS OR

OTHER OBJECTS INTO A MOVING FAN.

Installation

HUMIDIFIER MAY NOT BE INSTALLED WHERE IT MIGHT BE EXPOSED TO FREEZING

TEMPERATURES. IF THE COOLING UNIT IS MOUNTED OUTSIDE, THE HUMIDIFIER WILL HAVE

TO BE MOUNTED IN THE SUPPLY DUCT TO THE CELLAR INSIDE THE BUILDING OR MOUNTED

AS A FREESTANDING UNIT INSIDE THE CELLAR.

Pre-Installation Check

To check for any possible non-visible shipping damage, you may wish to test the unit before
actually installing it. To do so, remove the unit from its packaging and set it on any sturdy level
surface. If a freestanding unit, plug in the unit. If the unit is to be mounted into a cooling unit,
you need to wire the humidifier to the cooling unit and the cooling unit must be turned on. Set
the humidistat above the room humidity. The unit should now come on. The water solenoid
should open and the fan should come on. Listen for any unusual noise or vibration. Turn the
humidistat below the room condition and the unit should go off.

NEVER MODIFY THIS EQUIPMENT. CHANGES OR MODIFICATIONS MAY VOID THE

WARRANTY, CAUSE DAMAGE TO THE EQUIPMENT, AND/OR CREATE A SAFETY
HAZARD.

NEVER PLACE ANYTHING ON TOP OF THE UNIT. NEVER BLOCK OR COVER ANY OF

THE OPENINGS OR OUTLETS OF THE UNIT.

NEVER ALLOW ANYTHING TO REST ON OR ROLL OVER THE POWER CORD, AND

NEVER PLACE THE UNIT WHERE THE POWER CORD IS SUBJECT TO WEAR OR
ABUSE.

DO NOT REMOVE OR OPEN ANY ACCESS DOOR OR COVER UNLESS THE UNIT IS

UNPLUGGED.

CAUTION

CAUTION

DANGER