Vinten Radamec Fusion FH-100 - Manual (Page 31)

18
Maintenance
Routine checks
During use, check the following:
• Check the balance of the head. Re-balance as necessary.
• Check the data communication with the control panel. Re-fit cables if necessary.
• Check lens zoom and focus communication with the Head. Re-fit cables if necessary.
No further routine maintenance is required.
Regular cleaning
We encourage regular cleaning of the product.
• Do not use oil or grease on any exposed part of the equipment. This is unnecessary and traps dirt which
acts as an abrasive.
• Do not use solvent or oil based cleaners, abrasives or wire brushes to remove accumulations of dirt as
these damage the protective surfaces. To clean mechanical surfaces, use only detergent based cleaners.
• External electrical connection ports should only be cleaned with a semi-stiff brush or a vacuum cleaner.
During normal use the only cleaning required should be a regular wipe over with a lint-free cloth. Dirt
accumulated during storage or periods of disuse may be removed with a semi-stiff brush. Particular attention
should be paid to the four-hole mounting and camera mounting faces, along with all the connection ports.
!
Warning!
To reduce the risk of electric shock, do not remove
the cover. No user-serviceable parts inside. Refer
to qualified service personnel.
CAUTION! 1. Do NOT use oil or grease on any exposed part of the product. This is unnecessary and traps
dirt which acts as an abrasive.
2. DO NOT use solvent- or oil-based cleaners, abrasives or wire brushes to remove
accumulations of dirt as these damage the protective surfaces. To clean mechanical surfaces,
use only detergent-based cleaners.
3. External electrical connection ports should only be cleaned with a semi-stiff brush or a
vacuum cleaner.