Vintage Cellars Giant Wine Cellar - Manual (Page 4)

4
LAYOUT AND STORAGE
Your cabinet was designed to store a maximum number of bottles securely. We recommend that you observe the
tips below to optimize loading.
 Remove tape from shelves once unit is stable and ready for storage.
 Disperse the bottles evenly to avoid concentrating weight in one place. Bottles must not touch either the back of
the cabinet or the step at the bottom.
 Make sure that the bottles are not all grouped together either at the top or bottom of the cabinet.
 Only pull out one rolling shelf at a time. Never attempt to pull more than one.
 Maximum weight capacity per shelf is 55 lbs.
 You can increase your wine cellar’s storage capacity by removing shelves and stacking bottles on top of one
another. Do not stack more than 3 rows of bottles per shelf.
REMOVING THE ROLLING SHELF
To remove a rolling shelf:
1. Remove all bottles.
2. Pull the shelf out as far as it will go.
3. Push the left side lever downward while pushing the right side lever upwards (as illustrated below).
4. Remove the shelf.
REARRANGING SHELF LAYOUT
You can rearrange the configuration of your wine cellar by moving the location of your shelf brackets. To move a
sliding shelf, first remove all bottles then remove the rolling shelf as illustrated above. You are now ready to remove
the shelf guide rails.
To remove shelf slide rails:
1. Fully extend out the guide rail.
2. Lift the front of the guide rail upwards to separate from the wine cellar wall.
3. Pull guide rail towards you to completely release from wine cellar.
4. Do not mix up the left and right guide rails.