Vetter Litepod ART-LP - Manual (Page 7)

Page 7/14
Before deployment, make sure that the ART Lite Pod is complete and in
a flawless condition. Please ensure that all parts of the system are in
flawless condition. Even just one defective part can impair the reliable
functioning of the entire system. The ART Lite Pod must not be used if
there are signs of damage or if you have doubts about the flawless condi-
tion.
If the equipment has been stressed by a fall, the written consent of an ex-
pert person is required before the equipment can be deployed again.
A plan must be available about the rescue measures and the plan must be
taken into consideration when working on possible emergencies.
Do not make any modifications or undertake any supplements on the
equipment without prior, written consent from the manufacturer. Likewise,
perform corrective maintenance only in compliance with the measures sta-
ted by the manufacturer.
If you have any specific questions or doubts about the safety of the ART Lite
Pod, please get in touch with Vetter GmbH.
Caution! Check and if applicable re-tighten all
threaded connections before the deployment!
4. Preparing for use
4.1 Mission preparation
9 Check the local circumstances and adapt the strut length accordingly.
9 Get all parts of the set plus the accessories such as the karabiner snap
hooks, guide pulleys and cable winches ready.
9 Please make absolutely sure that there is sufficient space underneath
the user before each deployment to definitely exclude any possibility of
an impact on the ground or on another obstacle in case of a fall.
9 Please also note that the free fall is restricted to the minimum.
9 Make sure the slinging point is above the user.
9 The following hazards can impair the functioning of the equipment and
must always be avoided: e.g., extreme temperatures, stress on the con-
nectors due to sharp edges, slack ropes, effects of chemicals, electrical
influences, cuts, abrasion, climatic impacts, oscillating motions during
falling.