Universal Remote Control (URS) MX-600 - Manual (Page 32)

31
7. Programming Macro Buttons
15. Press MAIN.
16. Press CABLE. (Back to the this device to enter the
appropriate channel.)
17. Press 1, then 3, then 5. (Then press the ENT button if
your cable device requires it.)
18. Press CH UP to save the macro.
19. Press MAIN twice.
Press M1 to test your macro.
It should turn on your Audio device (receiver for example),
then your TV, then your Cable box, then change the input
to Cable on your receiver, then change the Channel on your
Cable box to 135.
Note: You can end your macro on any page you like,
including the MAIN page. We deliberately ended our macro
on the Cable page before we saved it, since that is where
we wanted to be at the end of our macro.