Universal Remote Control (URS) MX-600 - Manual (Page 35)

34
A. Erasing Learned Buttons
1. Go to the SETUP mode by pressing both the MAIN and
ENTER buttons simultaneously for three seconds.
2. Press the ERASE button next to the LCD screen.
3. Press the LEARN button.
4. If you wish to erase all the learned functions in the
MX-600
TM , press the ALL button and then press the SURE?
button at the next LCD screen.
5. If you wish to erase all the buttons in a single device or
an individual button in the device, press the DEVICE
button.
6. Press the device button (TV, VCR, Audio, etc.) to erase
the button(s) from the device.
Tip: Press the PAGE button and then press the DEVICE
button (TV, VCR, Audio, etc.) to erase the learned function
in the device button itself. Programming this learned
function to the Device button was explained in
“Programming the Ten Device Buttons” earlier.
7. Press the ALL button if you wish to erase all the learned
buttons in the device and press the SURE? button at the
next LCD screen.
9. Erasing Existing Programming