Universal Remote Control (URS) UR3-SR3 - Manual (Page 7)

5
blink twice to confirm that the code has been
stored.
*Note : Try all the functions on the remote control. If any
of the functions do not operate as they should,
repeat the instructions from Step 2 using the next
three-digit code number from the same brand list.
D. Auto Search Method D. Auto Search Method
If none of the three digit code numbers assigned to your
brand of equipment works, or the code table does not list your
brand, you can use the Auto Search Method to find the
correct three-digit code number for your equipment by
following steps:
STEP1
Turn on the equipment that you want the remote
control to operate (Cable Box, TV, or DVD).
STEP2
Press the [DEVICE] button and the [OK/SEL]
button simultaneously for three seconds. The
device LED will turn on indicating that it is ready
to be programmed. The LED will remain on for 20
seconds. The next step must be entered while
the LED is on.
STEP3
Press the [CH
5] or [CH6] button one at a time or
keep it pressed. The remote will emit a series of
Power ON/OFF code signals. Release the [CH
5] or
[CH
6] button as soon as the equipment turns off.
*Note : You can verify that you selected the correct code
by pressing the [MUTE] button. The equipment
should turn On or Off.
STEP4
Press the same [DEVICE] button to store the
code. The Device LED will blink twice to confirm
that the code has been stored.
E. E. To find the Three-Digit Code that Was To find the Three-Digit Code that Was
P r o g r a m m e d u s i n g t h e A u t o S e a r c h P r o g r a m m e d u s i n g t h e A u t o S e a r c h
Method Method
STEP1
Press the appropriate [DEVICE] button and the
[OK/SEL] button simultaneously for three
seconds. The device LED will turn on for 20
seconds. The next step must be performed while
the LED is on.