Defaults, Defaults -10 – Cabletron Systems 9T428-16 User Manual
Page 24
Installation
2-10
Defaults
When the module is installed, the parameters listed below are the defaults. These
can be changed by Local Management or by SNMP management.
Ring Speed (or Media Rate)
Defaults to a 16Mbps ring speed.
Ring Numbers
Default to the Token Ring port number (i.e., port 3 = ring number 3). If
ÒAuto-Detect Ring NumberÓ is enabled and a RPS device is present, the ring
number will be set to the existing number in use on the attached ring segment.
Source Route Bridge Number
Defaults to one.
Virtual Ring Number
All ports are switched to an internal virtual ring. The number defaults to CAC.
C-Port Mode
Defaults to STN/RI for the 9T428-16 module. The 9T425-16 and 9T427-16 default
to AUTO - it automatically determines STN or LOBE when the cable is attached.
Bridge Type/Explorer Type
Defaults to TP/TP. This setting allows the port to receive Source Route and
Transparent frames, but transmits all frames to the ring segment connected to the
front panel as Transparent frames (TP). Unknown and broadcast (Explorers) are
also transmitted as transparent (TP) frames.