Symtech ETF 3 - Manual (Page 9)

9
GENERAL OPERATING NOTES
A. APPLICABLE TRANSMISSION SYSTEMS
The ETF 3 service is recommended every 15,000 miles or 12 months. For vehicles over
60,000 miles or with leaking problems such as a leaky gasket, replace the gasket and
correct any additional problems before doing the service. If changing transmission
filter/gasket is desired or required at the same time, do the regular filter/gasket change after
Transmission ETF 3 service.
B. LOCATING TRANSMISSION OIL COOLER LINES
Look for Transmission Cooler Lines entering into and exiting out of the RADIATOR. Select
ONLY One Cooler Line which is easiest to disconnect. That means there are now two open
ends to work with: one coming from the transmission and one going into radiator. See
Figure. A.
C. SELECTING ADAPTERS
Select suitable adapters for the two disconnected open ends.
D. FOLLOW STEP BY STEP OPERATING INSTRUCTIONS AS DESCRIBED IN THE
FOLLOWING QUICK REFERENCE GUIDES
Transmission ETF 3 Operators must be familiar with all Basic ATF Exchange procedures
before proceeding with exchange.
E. DRAIN USED ATF FROM ETF 3 USED FLUID TANK
Step 1 Set DRAIN USED FLUID SELECTOR to “Drain Used Fluid” position. Set FILL
ON/OFF Switch to "OFF".
Step 2 Connect one end of the CLEAR Used Fluid Drain Hose to “Used Fluid Drain
Port” and the other end to an used ATF collection container. Connect ETF 3
power cable to 12v D.C. battery. Buzzer should sound. Set Timer to 30 minutes.
Step 3 Set FILL ON/OFF switch to “On” and wait for all used ATF to be evacuated from
Used Fluid Tank.
Step 4 Set FILL ON/OFF switch to “Off” and disconnect Used Fluid Drain Hose from
“Used Fluid Drain Port”.
Step 5 Set DRAIN USED FLUID Selector to “Fluid Exchange” position.