Symtech ETF 3 User Manual
Page 5

5
Clean up automatic transmission fluid and/or chemical spills immediately and use proper
container for disposal.
Check all fittings and automatic transmission cooler lines for leaks before, during and
after performing the ETF 3 Service.
Keep ETF 3 hoses and electrical cords away from hot manifolds and all moving
components.
If you have any questions or problems which cannot be solved by reading this manual,
please contact your authorized Distributor, Symtech Representative, or Symtech
Corporation Customer Service Dept.
1.8 BATTERY CONNECTIONS
Batteries can produce explosive gases. To avoid a battery explosion and serious
injury, follow these important safety precautions whenever connecting to or working
near a battery.
1. Be sure that the machine's Exchange / Circulate Selector is in "Circulate" position.
2. Connect the positive (Red) battery lead to the positive battery terminal. The
negative (Black) lead should be attached to the negative battery terminal.
Keep lit cigarettes, open flames or other ignition sources away from the battery. NEVER
SET TOOLS OR METAL COMPONENTS ON OR NEAR THE BATTERY.
2. COMPONENT FUNCTIONS
2.1 CONTROLS, SWITCHES & INDICATORS
(1) CYCLE SELECTOR Select
Exchange or Circulate Mode.
(2) USED ATF DRAIN SELECTOR
Select Used ATF Drain Mode.
(3) FILL ON/OFF Turns on ETF 3
new fluid .
(4) POWER LIGHT Indicates the
ETF 3 is connected to the
vehicle battery.
(5) TIMER Sets desired Cycle time
in minutes and to turn off buzzer.
(6) PRESSURE GAUGE Indicates
system operating pressure.
(7) 10 AMP BREAKER Provides
circuit protection.
2.2 CONNECTIONS
(8) NEW FLUID HOSE (Red) Connects to Input
side of a disconnected AT cooler line.
1
3
4
5
6
7
17
15
2