Smart Power Systems HR-30 - Manual (Page 36)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 35 of 50
Time Since last Oil Filter
Change in Hours.
Press Mode until FLt
and Xr are displayed
Example of oil filter run time display
Figure 25
4.
The Command & Control Center will flash a fault when 250 hours have passed
since the previous filter change. After replacing the filter, this fault can be removed
from the Command & Control Center, and the filter run time can be reset by
performing the following steps:
Step a: Press Mode until InF,
0IL, and FILt appear.
Step b: Hold Mode switch
down and press On/Off three
times in a row to clear the
fault.
Procedure will also work
in the Oil Filter Hours
Information display
Example of oil filter service warning display
Figure 26
a. Press the Mode switch repeatedly until one of the screens shown in Figure
appears.
b. While holding the Mode switch down, press and release the On/Off switch three
times in succession, then release the Mode switch. The Oil Filter Fault display