Smart Power Systems HR-30 - Manual (Page 11)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 10 of 50
MODEL OF GENERATOR HR-20, HR-25, and HR-30
Oil Cooler
Dimensions (Core) 7.5”D x 18.9” W x 32.3”L
Fan
Voltage
Amperage
16 Inch Pusher
12 Volts DC
22 Amps
Filter 10 Micron
Hydraulic Oil
(recommended)
(alternate)
Maximum Viscosity
Op. Temp. range
(deg. F.)
Dexron III
ISO Approved Hydraulic Fluid
4600 SUS (1000mm2/S)
60 SUS (10mm2/S)
-13° F to 195° F
Hoses
Motor Inlet
All Others
SAE
6000 psi, SAE
1250 psi, SAE
Fittings SAE
Dry Weight
(without pump)
675 lbs
Dimension of Tray Asm. 40” L x 19” W x 22” H
(Including Reservoir)
Ambient Operating
Temperature Range
0
°F to 120°F
Table 1 (cont.)
Note 1: The HR-20, HR-25 and HR-30 systems can provide 84 amps, 105 amps and 125
amps respectively on each of their two 120 volt circuits as long as the circuit-to-circuit
imbalance does not exceed the maximum recommended value of 20% (See page 21 for
more information and warnings).
Note 2: The recommended PTO ratio is 1.29 : 1 (129%).
The recommended engine idle speed with this PTO is 750 RPM.
This will result in a 968 RPM pump drive input, thereby insuring 5KW
of available power at engine idle. If full output is required at idle speed, then a higher PTO
ratio must be chosen to create 1200 RPM pump drive at idle speed; however care must
be taken to prevent higher engine speeds from creating a pump speed that exceeds the
pump’s maximum speed.