Ring Communications DNA934P - Manual (Page 10)

DNA934P Telephone Dialer with Recorder February 2013
CONFIGURATION
One DNA100 and a PC is used for programming the DNA934P. The DNA100 sets up a link to
the DNA934P and the PC is used to input configuration commands. The configuration is
stored in battery back up memory in the DNA934P. When the system is first installed the
DNA934P must be reset before any configuration is done (see page 4).
Type fonts:
boldface type indicates user input
courier font indicates output
Prompt:
<> Angle brackets enclose input parameters
$ Hexadecimal value
Error Handling:
Misspelled command input will give the following message: Unknown Command
Parameter errors will print
ERROR:
then prompt for the parameter again.
Page 10
Ring-Master