Reliance Controls Pro/Tran - Manual (Page 13)

11
Optional Accessories
Power Inlet Boxes
Ideal for installations where the house electrical panel is located
indoors. No need to run the power cord from the generator to the
transfer switch through a door or window. This weather-tight power
inlet box can be mounted on the exterior of the house. Run wiring
through the wall from the inlet box to the transfer switch installation
inside. The generator power cord may then be plugged into the
power inlet box.
Catalog#
Connector
configuration
Inlet description For use with models
PB15 5-15 3-wire weather-tight male 15114A
PB20 L14-20 4-wire weather-tight male 20216A
PB30 L14-30 4-wire weather-tight male
All 30A Models
PB31 L5-30 3-wire weather-tight male 30114A
PB50 CS6364 4-wire weather-tight male All 50A Models
Flush Kits Hinged Covers
Power Cords
These heavy duty cord sets are the connecting link
between the generator and the Reliance transfer switch or
the power inlet box. The 4-wire locking plug and connector
match up with the power inlet on each Reliance transfer
switch and with the inlet on the power inlet box. Most
portable generators suitable for 120/240 full-power
operation are supplied with either a 20-amp or 30-amp, 4-wire locking receptacle that
accepts the locking plug and connector on each end of the cord set.
Watt Meter Panel
Kits for flush mounting
all Pro/Tran® indoor
transfer switches are
available. Order KF6
for the four- and six-
circuit models and
KF10 for the eight- and
ten-circuit models. High-impact clear
plastic covers protect
from accidental con-
tact with transfer
switch.
Order CK6 for
the four- and six-circuit
models and CK10 for
the eight- and ten-
circuit models.
Watt Meter Panel WP7500 may replace the blank cover on
any indoor suffix B Pro/Tan® model to provide important
information on the output from a 20A or 30A, 125/250VAC
generator. Accuracy is plus or minus 3%.