Reliance Controls Easy/Tran - CSR201 - Manual

I:\Reliance\MOF Reliance\Labels\LoadSide\CSR201 Oper Inst rev3.doc
NON AUTOMATIC TRANSFER
SWITCH - 68UN
RELIANCE EASY/TRAN ® TRANSFER SWITCH
MODEL NO: CSR-201
ELECTRICAL RATING: 20 Amps., 125 VAC, 50/60 Hz.
5 KA SHORT CIRCUIT WITHSTAND TYPE 3 ENCLOSURE
SUITABLE FOR USE IN ACCORDANCE WITH ARTICLE 702 OF THE NATIONAL ELECTRICAL CODE, ANSI/NFPA 70.
THIS PRODUCT MEETS OR EXCEEDS ALL REQUIREMENTS OF UL1008 STANDARD FOR TRANSFER SWITCHES.
WIRING
IMPORTANT: DISCONNECT ALL ELECTRICAL SUPPLY SOURCES BEFORE INSTALLATION AND
WHEN SERVICING CONNECTED EQUIPMENT OR CIRCUITS.
Remove the wiring compartment cover by loos ening the two screws that hold it in place, and lift out.
Four color-coded wire leads are provided. They are to be connected as follows:
RED:
To incoming utility line, 125 VAC.
WHITE: To neutral.
BLACK: To load, 125 VAC
GREEN: To ground bar or terminal.
Replace wiring compartment cover when wiring is completed.
USING THE RELIANCE TRANSFER SWITCH WITH A GENERATOR
THIS RELIANCE TRANSFER SWITCH IS NOT FOR "DO-IT-YOURSELF" INSTALLATION. Installer must be
thoroughly familiar with electrical wiring systems. This Reliance Transfer Switch is designed to provide, in the
event of a utility power outage, a safe and simple method of powering a single 125 volt circuit from a portable
generator with a 125 VAC output. The SPDT selector switch will feed the circuit load from either the utility or
the generator, and prevent backfeeding of one source from another.
KEY COMPONENTS OF THE TRANSFER SWITCH
SELECTOR SWITCH. Selects either "LINE" (utility) or "GEN" (generator) as the source feeding the circuit load.
POWER INLET. NEMA L5-20 configuration. Inputs power from the portable generator.
TRANSFERRING FROM UTILITY POWER TO GENERATOR POWER
1. Move the selector switch handle to the "OFF" or “LINE” position.
2. Insert the male power cord plug into the appropriate outlet on the generator. If locking receptacle is used,
rotate to lock.
3. Insert the female power cord connector into the power inlet located on the lower face of the transfer switch.
Rotate to lock.
4. Start the generator, following the procedures described in the generator owner's manual furnished by the
generator manufacturer.
5. Move the selector switch knob to the "GEN" position to energize load from generator.
TRANSFERRING FROM GENERATOR POWER BACK TO UTILITY POWER
1. Move the selector switch handle to the "LINE" position to energize load from utility.
2. Follow the procedures in the generator owner's manual to turn off the generator.
3. Disconnect the power cord.
RELIANCE CONTROLS CORPORATION
2001 Young Court Racine, WI 53404
FORM OPCSR201 101502
RED BLACK WHITE GREEN
SWITCH
POWER INLET
L5-20