ProgressiveRC 3010B iCharger - Manual (Page 4)

-4-
iCharger Synchronous Balance Charger/Discharger 3010B
process time. If any individual cell appears over-charged or over-discharged or the pack is too hot or the
process has gone on for too long, the iCharger will generate an alarm sound and the related information
will blink.
 Electric motor test mode can be used to run-in electric motors, test motor parameters and performance,
check tolerances etc.
 Foam-cut drive. In this mode, the charger acts as a convenient power supply for a hot wire foam cutter.
 Battery interior resistance measurement. The iCharger can not only measure the internal resistance of
the battery pack, and also can measure the per-cell internal resistance (only available for lithium battery).
 Perfect protection. The iCharger has protection for reversed polarity (input or output), low input voltage,
battery temperature, charging capacity and time overrun.
 iCharger 3010B has a 16Mbit flash storage, which can log offline charge and discharge data in 36 hours.
 Support upgrading the hardware program by USB port. The iCharger also support the ―logview‖
software and can display, plot and analyze the charge and discharge data by it. (See detail information
about logview in the following website:
http://www.logview.info )