Pridiom Solar Series Installation Manual User Manual
Page 13
Installation of the solar photovoltaic system
This guide contains information regarding the installation and safe handling of solar photovoltaic
module. All instructions should be read and understood before attempting to install. If there is
any question, please contact our sales department for further explanation. The installer should
conform to all the safety precautions listed in this guide when installing the module. Local codes
should also be followed in such installations.
This manual describes several typical systems of solar photovoltaic, but does not involve the
specific structures and installation procedures of the installation. Please consult the supplier for
the information of the following assemblys:
a) the specifications of the solar photovoltaic system;
b) cable material
c) connecting components
d) bracket and support
e) supporting parts .
Before installing a solar photovoltaic system, the installer should become familiar with the
mechanical and electrical requirement for such a system. Keep this guide in a safe place for
future reference (care and maintenance) and in case of sale or disposal of the module at the
end of its useful life.
Installing solar photovoltatic systems may require specialized skills and knowledge. Installation
should be performed only by qualified persons.
All modules come with a permanently attached junction box and #12 AWG teminated in
Muticontact PV-KBT4 or PV-KST4 connectors. We can provide customers with fitted cables
for ease of installation, if desired.
The installer should assume the risk of all injury that might occur during installation, including,
without limitation, the risk of electric shock.
The solar photovoltatic electrical energy production system must comply with the following
table for suggested current and voltage specifications:
One individual module may generate DC voltages greater than 30 volts when exposed to direct
sunlight. Contact with a DC voltage of 30V or more is potentially hazardous. Electrical joints such
as the wire terminal will cause sparks, burning or deadly electric shock. Please do not touch such
terminals directly under any circumstances.
General
Fi g.29
12
ELECTRICAL WORK
Optim um operating voltage(Vmp)
Open-circuit voltage(Vmp)
Short-circuit current(Vmp) Maximum power current(Pmax) Maximum Power Voltage(W) <700W Optim um operating voltage(Vmp) >DC20V PDF created with pdfFactory Pro trial versi