Pridiom Solar Series Installation Manual - Manual (Page 12)

11
ELECTRICAL WORK
Connect the cable to the outdoor unit
1. Remove the electrical control board cover
from the outdoor unit by loosening the screw
as shown in Fig.28.
2. Connect the connective cables to the
terminals as identified with their respective
matched numbers on the terminal block of
indoor and outdoor units, Fig.27.
3. Secure the cable onto the control board with
the cord clamp.
4. To prevent the ingress of water, from a loop
of the connective cable as illustrated in the
installation diagram of indoor and outdoor
units.
5. Insulate unused cords (conductors) with
PVC-tape.Process them so they do not
touch any electrical or metal parts.
Cover
Screw
Fig. 28
7. Reinstall the electrical box cover, keep the
white band just under the groove as shown in
Fig. 26a and curve the cable into the groove.
Make sure the cable connected with LED
display window is fixed by the electrical box
cover after installation, Fig.26b.
Fig.26b Fig .26a
Band Cabl e connected
with L ED display
wind ow
Groo ve
Fig .27
Terminals on the
o utdoor u nit
Terminals on the
indoor unit
S L1 L2
Y/G
Y/G
L1 L2 S L1 L2
To power supply
L1 L2
To solar panel
Circuit Bre aker
PDF created with pdfFactory Pro trial version www.pdffactory.com