Origin Live Resolution MKI - Manual (Page 2)

Page2
Introduction (read carefully)
Congratulations on choosing your Origin Live turntable. You now have one of the finest sounding turntables available – not only
will it provide an extraordinary level of performance but also reliability and low maintenance.
It is critical that these instructions are read fully to achieve optimum performance from your turntable. There are aspects of
the deck that run contrary to what you may expect, so before altering anything it is important to fully read the manual or
degradation will result.
The Resolution turntable is simple to set up. If you have a problem please refer to the instructions. If your problem persists you
should speak to your dealer or refer to Origin Live technical support at web site address - ‘www.originlive.com’ under “general
information” then ‘technical support’ from the drop down list.
The instructions are written for people with no previous experience of turntables. Some sections may therefore appear lengthy,
as they need to cater for all potential questions. When reading the instructions refer to the various diagrams for part names and
clarity.
The body text in grey is of secondary importance and can be read later if you can’t wait to get your deck up and
running.
The deck can take approximately 15 minutes to set up depending on your expertise. The dc regulator electronics may initially
encounter speed drift when first started (if they have not been run in). You may need at least 4 hours to run in before the speed
can finally be set with accuracy.
We wish you an enjoyable time with your Resolution turntable.
Parts list
 Plinth & gloves
 Turntable bag
o Belt
o 1 cable clip and attachment screw - (may be on plinth)
o Oil bottle
o 3mm Allen key & 2.5 mm Allen key
o Spring seat, 1 rubber washer, serrated washer & spring
o 3 cork discs for levelling if necessary
 Platter
 Sub-platter
 Sub-chassis
 DC100 motor in Motor pod
 Control box
 Transformer for 230 volt or 110 volt mains supply
 Arm (optional), alignment gauge, but no arm instruction sheets as included in deck instructions
P A P E R W O R K
 Turntable instructions & strobe card