Modern AG 15' Raptor - Manual (Page 44)

44 - 15’ Raptorrr
OPERATION SECTION
Transport Position
to raise cutter wings, drive the unit to a level area and retract the wing hydraulic cylinders. DO nOt
raise wings with the cutter positioned on an embankment or other inclined position to prevent
overturning the cutter. after the wings are fully raised, install transport lock braces to prevent wings
from inadvertently falling. nOte: If the transport lock braces can not be easily installed, lower the
cutter wings and remove rod end of cylinder and adjust the rod clevis in or out to match the
transport brace length.
The center of gravity is raised and the cutter more prone to tipping when the wings are in the raised
position. When transporting, only raise the center section high enough to clear ground obstacles.
When the Wings are folded for transport, the center of gravity is raised and the possibility of
overturn is increased. Drive slowly and use extreme caution when turning on hillsides. Overturning
the Implement could cause the Implement to overturn the Tractor and vice versa resulting in serious
injury or even death. never fold wings on a hillside... the Implement may overturn.
Operating Position
to lower the wings, remove the transport lock braces and secure braces on storage bracket. DO nOt
drive out transport brace pins. the wing cylinder may need to be retracted to remove tension for
brace removal. after removing brace bars, extend wing hydraulic cylinders and fully lower wings.
the valves operating wing cylinders should be placed in the float position while mowing to allow the
cutter to follow the contour of uneven terrain and to prevent the wings from creeping up. When
extending a wing over a ditch for mowing, place the control valve lever detents in the center position.
this will give the cutter more stability and prevent the opposite wing from raising. DO nOt operate
the cutter with the valves in the detent position for extended periods of time to prevent deck frame
damage.
use extreme care when lowering or unfolding the implement’s wings. make sure no bystanders are
close by or underneath the wings. allow ample clearance around the implement when folding or
unfolding the wings. use extreme caution around buildings or overhead power lines.
DANGER
WARNING