beautypg.com

Cisco 6961 User Manual

Page 2

background image

2-2

Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP)

OL-20851-01

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network

Understanding Interactions with Other Cisco Unified IP Telephony Products

Understanding How the Cisco Unified IP Phone Interacts with Cisco
Unified CM

Cisco Unified CM is an open and industry-standard call processing system. Cisco Unified CM software
sets up and tears down calls between phones, integrating traditional PBX functionality with the
corporate IP network. Cisco Unified CM manages the components of the IP telephony system—the
phones, the access gateways, and the resources necessary for features such as call conferencing and route
planning. Cisco Unified CM also provides:

Firmware for phones

Configuration file via TFTP service

Authentication and encryption (if configured for the telephony system)

Phone registration

Call preservation, so that a media session continues if signaling is lost between the primary CM and
a phone

For information about configuring Cisco Unified CM to work with the IP devices described in this
chapter, go to the

Cisco Unified IP Phone Configuration

chapter in the Cisco Communications Manager

Administration Guide.

For an overview of security functionality for the Cisco Unified IP Phone, see the

“Understanding

Security Features for Cisco Unified IP Phones” section on page 1-14

.

Note

If the Cisco Unified IP Phone model that you want to configure does not appear in the Phone Type
drop-down list in Cisco Unified CM Administration, go to the following URL and install the latest
support patch for your version of Cisco Unified CM:

http://www.cisco.com/kobayashi/sw-center/sw-voice.shtml

For more information, refer to “Software Upgrades” chapter in the Cisco Unified Communications
Operating System Administration Guide
.

Related Topic

Telephony Features Available for the Cisco Unified IP Phone, page 5-1

Understanding How the Cisco Unified IP Phone Interacts with the VLAN

The Cisco Unified IP Phone 6921, 6941, and 6961 have an internal Ethernet switch, enabling forwarding
of packets to the phone, and to the access port and the network port on the back of the phone.

If a computer is connected to the access port, the computer and the phone share the same physical link
to the switch and share the same port on the switch. This shared physical link has the following
implications for the VLAN configuration on the network:

The current VLANs might be configured on an IP subnet basis. However, additional IP addresses
might not be available to assign the phone to the same subnet as other devices connected to the same
port.

Data traffic present on the VLAN supporting phones might reduce the quality of Voice-over-IP
traffic.

Network security may indicate a need to isolate the VLAN voice traffic from the VLAN data traffic.