Mercedes-Benz CL-Class 2004 Owners Manual - Manual (Page 151)

150
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
the
æ or ç button to the LIGHT-
ING submenu.
̈ Press button j or k repeatedly
until you see this message in the dis-
play:
LIGHT CIRCUIT HEADLAMP MODE .
The selection marker is on the current
setting.
̈ Press æ or ç to select manual
or daytime running lamp (constant)
mode. This function is not available in
countries where daytime running
lamps are mandatory.
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps (in low ambient
light conditions)
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U, the locator lighting fea-
ture is activated and the vehicle is un-
locked by remote control:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
To activate locator lighting:
̈ Make sure the function LOCATOR
LIGHTING is set.
̈ Turn the exterior lamp switch to
position
U.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
LIGHTING submenu to factory settings
( ୴ page 146) while driving will not re-
set the daytime running lamp mode.
In the display you will then see the mes-
sage:
LIGHTING – CANNOT BE RESET
COMPLETELY FACTORY SETTINGS WHILE
DRIVING
.