Releasing seat belts, Locking, Releasing seat belts locking – Mercedes-Benz E-Wagon 2006 Owners Manual User Manual
Page 63
62
Getting started
Parking and locking
Releasing seat belts
̈
Press the seat belt release button
(
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
Locking
̈
Exit the vehicle and close all doors and
the tailgate.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Warning!
G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure that there
is no possibility of someone getting caught
in a door during closing.
Warning!
G
When leaving the vehicle, always take the
SmartKey or the SmartKey with
KEYLESS-GO* with you, and lock the vehi-
cle. Do not leave children unattended in the
vehicle, or with access to an unlocked vehi-
cle. Unsupervised use of vehicle equipment
may cause an accident and/or serious per-
sonal injury.
i
A warning sounds and the message
Switch off lights
appears in the mul-
tifunction display if the vehicle’s exteri-
or lamps are not switched off
ț
with the SmartKey removed from
the starter switch and the driver’s
door open
ț
with the engine turned off using the
KEYLESS-GO* start/stop button
and the driver’s door open (same as
SmartKey removed from starter
switch)
Switch off the exterior lamps.