Mercedes-Benz SL-Class 2006 Owners Manual User Manual
Page 252
251
Controls in detail
Useful features
̈
While still holding down the signal
transmitter button (
2, 3 or 4),
“cycle” your hand-held remote control
button
6 as follows: Press and hold
button
6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, the
indicator lamp
1 will flash slowly and
then rapidly after several seconds.
̈
Proceed with programming step 5 and
step 6 to complete.
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈
Switch on the ignition (
̈
Press and hold the desired signal
transmitter button (
2, 3 or 4).
Do not release the button.
̈
The indicator lamp
1 will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.
i
Upon completion of programming the
integrated remote control, make sure
you retain the hand-held remote con-
trol that came with the garage door
opener, gate operator or other device.
You may need it for use in other vehi-
cles, for future programming of an
integrated remote control, or simply for
continued use as a hand-held remote
control to operate the respective
device in other situations.